Poison Spyder - JK Brawler MID Front Bumper With Brawler Bar
JK Brawler Mid Front Bumper - Black Powdercoat Finish
Plate Steel Construction
This bumper is fabricated from 3/16" plate steel, CNC laser-cut and precision brake-formed into a low profile, high clearance design. The ends of the bumper extend far enough to protect the lower corner of the JK grille, but not far enough to hinder tire clearance or tire access to vertical obstacles.
The Brawler Bar is modeled after the bar found on our original RockBrawler™ front bumper. It is a low-profile stinger designed to provide protection to the winch, grille and radiator area. The Brawler Bar is made of CNC laser-notched, NC-bent 1¾" diameter .120" wall DOM tubing. The complex laser-cut notch allows the Brawler Bar to be welded to two different planes on the surface of the bumper, providing incredible strength. Two gusset styles are offered for strengthening the Brawler Bar. CNC laser-cut brake-formed 3/16" plate steel or CNC laser notched DOM tubing. Note: Warn PowerPlant winches are not a direct-fit with the DOM Tube gussets (they may be installed with some minor modifications by the installer).
Unlike the Poison Spyder BFH™ series bumpers for JK, the Brawler™ MID can be mounted without cutting or altering the Jeep's frame rails. The faceted design of the Brawler™ MID provides the best ground clearance and approach angle possible in a bumper that doesn't require frame modifications. The factory "Crash Bar" may be left intact or removed for a sleek appearance and high clearance.
Recessed Fog Lamp Mounts
Brawler™ MID comes with provisions for re-mounting your factory fog lamps.
The Brawler™ MID bumper is designed to accept most Warn winches, and winches from other manufacturers that conform to Warn's standardized winch mounting dimensions. The winch sits in a slight depression on the top surface of the bumper, with plenty of CNC laser cut plate steel gusseting inside the bumper shell, directly underneath the winch to provide maximum strength.
IMPORTANT: Warn Powerplant winches do NOT fit on the JK Brawler MID Front Bumper with Brawler Bar.
Recovery Shackle Tabs
The Recovery Shackle Tabs(2) are modeled after the high clearance tabs designed for our hard core BFH series bumpers. These tabs are angle to provide maximum approach angle. They are CNC machined from 1" thick steel billet, specifically designed to accept our heavy duty 3/4" Recovery Shackles.
Fits: 2007-2018 JK and JKU Wranglers